COMPATIBILITY

Refer to the table below for fitment information with popular Toyota engines. If an engine is not listed, fitment information has never been confirmed.

20-0408

This fitting is a direct replacement for the PCV valve located on the intake side valve cover(s).

Installed height: 1.19"

COMPATIBILE ENGINES

Toyota 1JZ-GE VVT-i
Toyota 1JZ-GTE VVT-i
Toyota 1JZ-GTE Non VVT-i
Toyota 2JZ-GTE VVT-i
Toyota 2JZ-GTE Non VVT-i
Toyota 2JZ-GE Non VVT-i
Toyota 2JZ-GE VVT-i (from 2000 to May 2002 ONLY)

20-0409

This fitting is a direct replacement for the crankcase vent press-in located on the exhaust side valve cover. The installed height is 1.19"

COMPATIBILE ENGINES

Toyota 2JZ-GTE VVT-i
Toyota 2JZ-GTE Non VVT-i
Toyota 2JZ-GE VVT-i
Toyota 2JZ-GE Non VVT-i

20-0509

This fitting is a direct replacement for the crankcase vent press-in located on the exhaust side valve cover.

Installed height: 1.19"

COMPATIBILE ENGINES

Toyota 1JZ-GTE VVT-i

20-0609

This fitting is a direct replacement for the crankcase vent press-in located on the exhaust side valve cover.

Installed height: 1.19"

COMPATIBILE ENGINES

Toyota 1JZ-GTE Non VVT-i

Fitting part number 20-0408 will work in many Toyota/Lexus models, some are listed below. If the PCV valve is mounted to the valve cover with rubber grommet P/N: 90480-18001 (shown below), then Radium P/N: 20-0408 will work with the grommet removed.

OEM Toyota grommet part number 90480-18001

4RUNNER
ARISTO
CAMRY
CARINA 2
CELICA 5S-FE
CELICA 7A-FE
CELSIOR
CHASER (excluding 2JZ-GE VVT-i)
COASTER
COROLLA SPRINTER
CORONA FR
CRESSIDA
CRESTA
CROWN (excluding 2JZ-GE VVT-i)
ES300
GS300 (excluding 2JZ-GE VVT-i)
GS400
GS430
HIACE S.B.V
HILUX
IS200
IS300 (2000-MAY 2002 ONLY)
LAND CRUISER
LS400
LS430
LX470
MARK II
MARK II BLIT (excluding 2JZ-GE VVT-i)
MR-2 5S-FE
ORIGIN (excluding 2JZ-GE VVT-i)
SC300
SC400
SC430
SEQUOIA
SOARER (excluding 2JZ-GE VVT-i)
STARLET
SUPRA 2JZ-GTE
T100
TACOMA 3RZ-FE
TACOMA 2RZ-FE
TUNDRA 2UZ-FE

OVERVIEW

Radium Engineering 10AN low profile swivel fittings convert the OEM PCV valve and/or OEM crankcase breather ports from their original barb fittings into a 10AN male swivel fitting connection for use when converting to large breather lines for a competition catch can with large breather lines. These install by simply pressing in to the valve cover. No drilling or welding is required.

Note: when installing these fittings in place of a PCV valve, a new PCV valve will need to be installed inline or on the catch can in order to maintain the connection to the intake manifold.